|
Description |
Downloads |
Specs |
Ordering |
|
|
A1018B |
|
- Power supply: 9V-24V DC/AC
- Frequency: 433.92 Mhz, 315 Mhz
- Max Consumption: 200mA
- Decoding: Binary
- Max Codes: 140
- Channels: 2
- Outputs: NO/NC 2
- Max Switching Power: 0.5A / 120VA
- Working Distance: 100m
- Relay Spec.: 12A 14VDC or 7A 120VAC
|
|
This 433MHz fixed code remote control switching system allows you to switch connected devices on and off remotely. It could be integrated with fans, LED lighting, cameras, doors, locks, motors and much more! Package includes two dual button remote transmitters and receiver unit. Two channels are available, both with dedicated relays (rated a |
|
AW1020A |
|
|
|
The Waterproof PentaFOB® works in conjunction with our standard PentaFOB® remotes and PCR series of
receivers. It uses frequency hopping spread spectrum (FHSS). |
|
S5387A |
|
- Symmetrically-shaped. Reversible for right-hand or left-hand doors.
- Shallow design for use with most doors.
- Powered by a solenoid, not a buzzer coil.
- Stainless steel lip (keeper) for strength and long life.
- Jaw strength: 2000-lb (900kg)
- Non-polarised connection. Wires can be reversed.
- Tested to 1 million cycles.
- Fail-Secure circuit:
- Door remains locked when power is disconnected.
- Perfect for entrance door installations.
|
|
Door strike for controlling building access points. Reversible design suits left or right hand hinged doors. |
|
S5335 |
|
- Retro-reflective beam sensor
- 7 metre detection range
- ‘Ding-dong’ or siren sound
- Adjustable speaker volume, plus off setting
- Adjustable siren length 3-30 seconds
- 9V DC operation
- Pluggable design, no hard wiring required
- Optional counter available, ideal for shops
- Includes mounting brackets
|
|
This handy entry alert system sounds whenever its infra red beam is broken. It is ideal for shops, receptions and sales areas. The extended 7 metre range is perfect for wide sliding/automated doors. The in-built speaker can be switched between alarm, chim |
|
S0158 |
|
- “No touch” Operation
- Rugged 38mm Stainless steel enclosure
- 12-24V DC operation
- Adjustable sensitivity from 4-15cm
- Adjustable on time from 0.5-30seconds
- Can be set to toggle ON/OFF
- NO/NC relay contacts
- Easy Installation
- IP65 Rated
|
|
The S 0158 proximity switch can be programmed to unlock an electronic door lock with a wave of your hand in front of the sensor. The IP65 rating enables the switch to be mounted to a wall plate at an indoor or outdoor location. It can be configured to either momentary or ON/OFF activation. |
|
A1025A |
|
- One channel receiver pre wired with relay output
- 12-way dip switch coding or one of over 17 billion encrypted codes.
- Frequency hopping
- Supply voltage can be AC or DC
- Antenna diversity
- Compatible with A 1017A and A 1021A remotes
- Unlimited remotes can be programmed to the receiver
- Highly sensitive receiver input stage
- Crystal controlled for high reliability
- Modes include Momentary and Latching
- Easy mounting to cases or walls
|
|
This receiver is compatible with A 1017A and A1021A remotes. The receiver is so small that it can be easily installed into your existing automatic gate opener or garage door controls. |
|
A1027A |
|
- Two channel receiver with relay output
- 12-way dip switch coding or one of over 17 billion encrypted codes.
- Supply voltage can be AC or DC
- Antenna diversity
- Frequency hopping
- Compatible with A 1017A and A 1025A remotes
- Unlimited remotes can be programmed to the receiver
- Highly sensitive receiver input stage
- Crystal controlled for high reliability
- Modes include Momentary and Latching
- Easy mounting to cases or walls
|
|
This receiver is compatible with A 1017A and A 1025A remotes. The receiver is small and can be easily installed into your existing automatic gate opener or garage door controls. |
|
A1029A |
|
- Frequency hopping between 433.10 to 434.70MHz
- 12-way DIP switch or encrypted coding
- Momentary and latching modes are user selectable.
- Unlimited remotes can be programmed to the receiver
- Antenna diversity for robust link with extended range
- Compatible with PentaFOB® and PentaCODE® remotes
- Wide operating supply voltage and low current consumption
- On-board diagnostic LED’s to indicate correct power, reception and relay activation
|
|
This receiver is compatible with FOB433 remotes. The receiver is small and can be easily installed into your existing automatic gate opener or garage door controls. |
|
S5377 |
|
- Weather resistant design (IP54)
- Vandal resistant
- Compatible with 125KHz 64-bit EM cards & key fobs
- Built-in logics for stand alone, split-decoded and multi-station operations
- Controls “Going In” with user codes/cards
- “Going Out” with feature programmable egress button
- Door Bell for guests/service persons /tradesmen
- Stainless steel faceplate
|
|
This weatherproof vandal resistant door keypad controller is designed for controlling a door strike in home or business security installations. It combines a digital keypad and proximity EM card reader in one unit. |
|
S5377A NEW
|
|
- Weather resistant design (IP65)
- Vandal resistant
- Compatible with 125KHz 64-bit EM cards & key fobs
- Built-in logics for stand alone, split-decoded and multi-station operations
- Controls “Going In” with user codes/cards
- “Going Out” with feature programmable egress button
- Door Bell for guests/service persons /tradesmen
- Stainless steel faceplate combines with die-casting metal back-lit key buttons
- Die-Cast Zinc Alloy Protection Bracket for Surface Mount
|
|
This weatherproof vandal resistant door keypad controller is designed for controlling a door strike in home or business security installations. It combines a digital keypad and proximity EM card reader in one unit. |