|
Description |
Downloads |
Specs |
Ordering |
|
 |
Y1860 ROHS
|
|
- 128KB of flash and 16KB of SRAM
- Up to 48MHz operating frequency
- Six serial communication modules (SERCOM) configurable as UART/USART, SPI or I2C, three 16-bit timer/counters, 32-bit Real-Time Clock and calendar, 20 PWM channels, one 14-channel 12-bit ADC, one 10-bit DAC
- Full Speed USB 2.0 Device and embedded Host
- Support for up to 120 touch channels
- 1.62V to 3.63V power supply
- Easy pin migration to SAMD21G and SAMD21J devices
- Supported by Atmel Studio, ASF and the SAM D21 Xplained Pro kit
- 38 GPIOs
- Operates between-40ºC and 85ºC
|
|
A low-power, high-performance Microchip's ARM® Cortex®-M0+ based flash microcontroller, the ATSAMD21G17 is ideal for a wide range of home automation, consumer, metering, and industrial applications. As used in the Arduino Zero. |
 |
Y1870 ROHS
|
|
- ARM Cortex-M3 revision 2.0 running at up to 84 MHz
- Memory Protection Unit (MPU)
- 24-bit SysTick Counter
- Thumb®-2 instruction set
- Nested Vector Interrupt Controller
- 2 x 256Kbytes embedded Flash, 128-bit wide access, memory accelerator, dual bank
- 100(64+32) Kbytes embedded SRAM with dual banks
- 16 Kbytes ROM with embedded bootloader routines (UART, USB) and IAP routines
- Static Memory Controller (SMC): SRAM, NOR, NAND support.
- NAND Flash controller with 4 Kbytes RAM buffer and ECC
- External Bus Interface - 16 bits, 8 chip selects, 23-bit address
|
|
Based on the ARM® Cortex®-M3 processor, the Microchip's SAM3X8E runs at 84MHz and features 512KB of flash memory in 2 x 256KB banks and 100KB of SRAM in 64KB +32KB banks, with an additional 4KB as NFC (NAND Flash controller) SRAM. |
 |
Z4980 |
|
|
|
DSPIC 33FJ128GP802
Genuine PIC micro controllers as used in several designs published in electronic magazines. See Books section for books on how to program and use micro controllers. |
 |
Z5005 |
|
|
|
PIC12C508A-04-P
Genuine PIC micro controllers as used in several designs published in electronic magazines. See Books section for books on how to program and use micro controllers. |
 |
Z5060 |
|
- 35 (14-bit wide) easy instructions to learn
- 8 level hardware stack
- 1 (9-bit) file select register
- Hardware interrupt handling
- 256bytes of EEPROM data memory
- Power on reset (POR)
- Watch dog timer (WDT)
- Two 8-bit digital timers
- One 16-bit digital timer
- In-Circuit Serial Programming™ (ICSP™)
|
|
The PIC16F88-I/P is a mid-range PIC16 family 8-bit powerful (200 nanosecond instruction execution) yet easy-to-program (only 35 single word instructions) CMOS flash based Microcontroller packs powerful PIC®(RISC) architecture. |
 |
Z5065 ROHS
|
|
|
|
PIC16F84A-04/P
Genuine PIC micro controllers as used in several designs published in electronic magazines. See Books section for books on how to program and use micro controllers. |
 |
Z5067 ROHS
|
|
|
|
Genuine PIC micro controllers as used in several designs published in electronic magazines. See Books section for books on how to program and use micro controllers. |
 |
Z5069 ROHS
|
|
|
|
Genuine PIC micro controllers as used in several designs published in electronic magazines. See Books section for books on how to program and use micro controllers. |
|
Z5070 ROHS
|
|
- High performance RISC CPU
- Only 35 single word instructions to learn
- All single cycle instructions except for program branches which are two cycle
- Operating speed: DC - 20 MHz clock input, DC - 200 ns instruction cycle
- Up to 8K x 14 words of FLASH Program Memory,
- Up to 368 x 8 bytes of Data Memory (RAM)
- Up to 256 x 8 bytes of EEPROM Data Memory
- Pinout compatible to the PIC16C73B/74B/76/77
- Interrupt capability (up to 14 sources)
- Eight level deep hardware stack
- Direct, indirect and relative addressing modes
- Power-on Reset (POR)
- Power-up Timer (PWRT) and
- Oscillator Start-up Timer (OST)
- Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
- Programmable code protection
- Power saving SLEEP mode
- Selectable oscillator options
- Low power, high speed CMOS FLASH/EEPROM technology
- Fully static design
- In-Circuit Serial Programming (ICSP) via two pins
- Single 5V In-Circuit Serial Programming capability
- In-Circuit Debugging via two pins
- Processor read/write access to program memory
- Wide operating voltage range: 2.0V to 5.5V
- High Sink/Source Current: 25 mA
- Commercial, Industrial and Extended temperature ranges
- Low-power consumption:
- - < 0.6 mA typical @ 3V, 4 MHz
- - 20 μA typical @ 3V, 32 kHz
- - < 1 μA typical standby current
|
|
PIC16F877-20/P |
 |
Z5105 |
|
- High-performance, Low-power AVR® 8-Bit Microcontroller
- Advanced RISC Architecture
- Non-volatile Program and Data Memories
- debugWIRE On-chip Debug System
- In-system Programmable via SPI Port
- External and Internal Interrupt Sources
- Low-power Idle, ADC Noise Reduction and Power-down Modes
- Enhanced Power-on Reset Circuit
- Programmable Brown-out Detection Circuit
- Internal Calibrated Oscillator
- 0 to 20MHz at 4.5 to 5.5V Speed Grade
- 1MHz, 1.8V, 300µA Active Mode, 0.1µA at 1.8V Power-down Mode Low Power Consumption
|
|
ATTINY85-20PU 8 Pin DIL Atmel Microcontroller. |
 |
Z5125 |
|
|
|
ATMEGA328-28PU
28 Pin DIP
Atmel Microcontroller. |
 |
Z5765 |
|
|
|
AT90S4433-08-PC |
|
Z6114A |
|
- Pack size 40x10x15mm
- Pack weight 2.9g
- Memory Capacity (bytes): 2048
- RAM (bytes) : 512
- Byte Variables (bytes): 28
- Input/Outputs Pins : 18
- ADC/Touch Pins: 11
- Max. Freq. (MHz): 32
- Serial In/Out: Yes
- Infrared In/Out: Yes
- I2C: Yes
- Tune (ring tones): Yes
- Parallel Tasks: 8
- Program Slots: 1
|
|
A compact but powerful, PICAXE microcontroller. Very popular in education due to its low cost and small size, but also very popular in a wide range of hobbyist projects.
This chip supports up to 18 inputs/outputs with 11 analogue/touch sensor channels.
All M2 series parts support enhanced features such as configurable i/o pins, parallel tas |
|
Z6127 |
|
- Pack Size: 50x10x15 mm
- Pack Weight: 4.2g
- Memory Capacity (bytes): 4096
- RAM (bytes): 1280
- Byte Variables (bytes): 56
- Input/Outputs Pins: 22
- ADC/Touch Pins: 16
- Max. Freq. (MHz): 64
- Serial In/Out: Yes
- Infrared In/Out: es
- I2C: Yes
- Tune (ring tones): Yes
- Parallel Tasks: 1
- Program Slots: 4
|
|
A very popular enhanced X2 PICAXE microcontroller. Favoured in hobbyist projects due to its powerful features and capabilities, but also suitable for more advanced educational use. This is the universal voltage version 28X2 chip (based on the PIC18F25K22).
The 28X2 supports up to 22 inputs/outputs with 16 analogue/touch sensor channels with an |
